UniDOS Notes  --  Version 1.27 (Z) --  July 14, 1988


Because UniDOS is constantly changing, please be sure to send in 
your registration card so we can inform you of new versions and 
products.

NOTES FOR Z80 COPROCESSOR VERSION OF UniDOS

The version of UniDOS that is supplied with the Z80 coprocessor 
card does not contain support for a V Series chip or the Z80 
interpretive mode.  These modes of operation are not needed with 
the coprocessor card and any references to them in the manual 
should be ignored.  UniDOS will still operate as described in the 
manual.


PROGRAMS THAT WILL NOT RUN WITH UniDOS

Osborne 1 Supercalc - The version of Supercalc that was bundled 
                      with the Osborne 1 computer will not work 
                      with UniDOS because it was written to 
                      directly access the Osborne 1 screen memory.  

Morrow NewWord -      The Version of NewWord that was bundled 
                      with Morrow computers is modified to work 
                      only on a Morrow machine.  This version of 
                      NewWord will do a BDOS version check call 
                      before saving or printing a file.  UniDOS 
                      will tell NewWord that it is CP/M 2.2 
                      compatible.  NewWord will then assume that 
                      it is running on a Morrow MD2 or MD3.  
                      NewWord will then try to turn on the Morrow 
                      ROM and check the values of a couple of 
                      locations in the ROM.  Since the ROM does 
                      not exist in a non-Morrow machine, NewWord 
                      will terminate when it doesn't find the 
                      proper values.


UniForm-PC Notes  --  Release 2.16  --  July 14, 1988


Because UniForm-PC is constantly changing, please be sure to send 
in your registration card so we can inform you of new versions 
and products.

After UniForm-PC is installed, it will create a new drive letter 
on your computer.  This often leads to some confusion for new 
users.  Please read Section 3.1 before using UniForm-PC.  It may 
save you a call to our technical support line.

To change menus in the UNIFORM program, the menu number must be 
followed by a RETURN.  This isn't mentioned in the manual because 
the UNIFORM program has recently been altered to support more 
than 9 menus.  If you use the UNIFORM program with command line 
options, make sure that you include a /R after specifying a new 
menu number.

Superbrain format users: If you get a read error when you try to 
use a Superbrain format diskette, run the FIXSUPER program.  The 
errors occur because the Superbrain computer initializes its 
diskettes improperly.  The FIXSUPER program is self documenting 
and will make your diskettes readable by UniForm-PC.

If you want to use Apple SoftCard or NorthStar format CP/M 
diskettes with UniForm-PC, you'll need to install a MatchPoint-PC 
card in your computer before those formats will appear in the 
UniForm-PC menu.  MatchPoint-PC cards are available from your 
dealer or Micro Solutions direct.

If you want to add an 8 inch drive to your system, you will need 
a Micro Solutions CompatiCard diskette controller.  CompatiCard 
is a half-size floppy disk controller card for the IBM PC, XT, 
AT, or compatibles.  It can accomodate up to four drives in any 
combination of 5 inch (48 TPI, 96 TPI or high capacity AT), 8 
inch, and 3.5 inch models.  It also supports single density on 
all drives and can be used in computers with non-removeable 
diskette controllers.

Thank you.

Micro Solutions Computer Products